Procedure
10 steps, target ≤ 20 min
| Step | Result | Tools | Team provides |
|---|---|---|---|
| Setup | |||
| 01Open case, switch on stands | 4 stands on the tablet | Tablet, offline | – |
| 02Jack up, wheels off | 4 hubs free | – | Jack, axle stands, wheel wrench |
| 03Fit hub adapters | Adapters on all 4 hubs Coupled rear wheels: both arms vertical | Adapters, assembled | Wheel nuts Socket ≤ Ø28 for bolt circle, ≤ Ø70 for centre lock |
| 04Place and level stands | 4 stands in one plane, target 0.1 mm Floating plate locked | Levelling feet M12, hex key 6 mm | – |
| 05Lower car | Pendulum axes seated Total weight = reference | Fine adjustment screw M10 × 1 | – |
| Measure and adjust | |||
| 06Ballast, steering, anti-roll bar | Steering 0.0° Anti-roll bar disconnected | Steering wheel inclinometer | Driver ballast |
| 07Measure | Wheel load, camber, toe per corner | – | – |
| 08Adjust with the software | Prediction per corner Car stays on the stands | – | Tools for spring perch, shim, tie rod |
| Finish | |||
| 09Countersign, export | Report with second signature CSV | Tablet | – |
| 10Pack up, charge | Stands in the case, batteries charging | USB-C charging set | – |